Strong Rubber Base Coat 2in1

It is a gel base to harden the natural nail and is used to complement semi-permanent nail polish.

Recommended for use in trade shows and for personal use at home.
Features:
- It has excellent adhesion (ensures perfect, air-free adhesion in the cuticle area);
- It is applied in a thin, even layer, sealing the sides of the nail without touching the cuticle.
- the base requires NO preparatory solutions (primer, nailprep, bonder, etc.)
- the product can be used before applying semi-permanent varnish or gel.
- with the rubber base you can seal the crystals (after drying the upper part, apply the transparent rubber base where the crystals will be, apply them, then polymerize). Caution! Do not apply the top on the crystals.
How to register:
1 Prepare the natural nail using the standard method: shape the nail, push back and remove cuticles, remove shine from the natural nail with a 180/240 fine file or buffer.
2. Apply a rubber base coat, then allow to cure for 30-60 seconds under an LED lamp or 120 seconds under a UV lamp.
2b. In the case of semi-permanent nail polish, apply a thin coat and without curing, apply a larger quantity of product, put it at cuticle level and pull towards the tip. Turn the customer's nail parallel to the table and position the apex according to the length of the nail, then check that the nail is not interrupted and cure for 60sec.
3. Apply 2 coats of color, each cured individually: 60sec under LED lamp or 120-180sec under UV lamp. / Apply gel.
4. Seal with Diamont Top Coat and cure for 60 seconds under LED light or 3-4 minutes under UV light.
Removal method :
4.enamel can be removed with a special solvent; for this method, you need Soak Off Remover/pure acetone and aluminum foil to remove the gel lacquer.
1 For the "soak off" method, put acetone or nail polish remover in a container or in special capsules and leave nails to soak for 10 to 15 minutes.
After 10-15 minutes, remove the nails from the liquid and remove any product residue with a metal spatula.